SHABAN CHEMICAL COMPANY First, drain the water remaining in the tank before disposing. Now disconnect the sensor cables and water inlet, the overflow hose and the drain hose. After disconnecting all power and water lines, the tank can be removed and taken out to be ready for repair. As previously mentioned, spraying or priming the system is bad because it can cause a pipe to burst, a crack in a corroded tank, or a valve, causing water to leak from the tank in a short time and causing damage. Heaters should not be installed in places where the instantaneous water heater can damage property, e.g in the attic. One solution can be to install a drip tray, water leak detector and shut-off device.
Water Tank Leakage Repair:
Replacing the entire hot water tank drain valve is usually the most reliable leak solution. However, you can try to gently tighten the valve with a wrench to check if the leak stops. Be careful not to over tighten the valve, otherwise leakage may increase or the valve may burst. Hang a garden hose in the drain valve at the bottom of the tank and allow it to drain to the floor. Make sure you empty the tank in a suitable place, e.g at drain or sink. Do not drain the lawn or driveway, as sediments and rust from the tank can damage the grass or the driveway. The first thing you need to do to repair the leakage of a concrete water tank is to measure the entire tank. Note the tank circumference and also measure the tank depth. You can easily measure the tank according to the dimensions you need using the tank insert. Any repairs to the fiberglass tank endanger the internal corrosion barrier of the fiberglass tank. Cylinder repairs that meet the scenarios described above can be effective and will not affect tank durability. Contact to Shaban Chemical Company, if you notice cracks or leaks in the tank or its fittings to avoid malfunction. Shaban Chemical provides its services all over Pakistan that includes Karachi, Lahore, Multan, Hyderabad, Sukkar, Quetta, Islamabad, Peshawar and Balochistan.